29. Run the red, black, and green wires to the power
supply and trim them so they run nicely to the
lower three terminals. Strip ¼ inch off the ends of
the wires. Loosen the terminals using a screw
driver. Insert the wires to the right of the screw.
That way when the screw is tightened down, it
pulls the wire in tight.
30. Take the red and black 14 awg wires and cut two
5 inch lengths of each. Strip ¼ inch off each end.
Connect the red wires to the positive terminals on
the power supply (there are three positive and
negative terminals and each wire should have its
own). Do the same for the black wires to the
negative terminals.
To Next Page
Loading...