27. Cut a two-inch piece of the black 14 awg wire and
strip ¼ inch off each end. Strip ¼ inch off the red,
black, and green 14 awg wires too. Solder (or use
up spade connectors If you have them) the green
wire to the top connector (pin 1) of the power
outlet. The red wire goes on the pin 2. The two-
inch black jumper goes from pin 3-4 and finally
the black 14 awg wire connects to pin 5.
28. On the front of the power outlet, remove the fuse
panel. Insert one of the fuses into the fuse slot
and the second fuse into the spare slot.
To Next Page
Loading...