Configuring health check monitors Firewall Load Balance
FortiGate Version 4.0 Administration Guide
394 01-400-89802-20090424
http://docs.fortinet.com/ • Feedback
Figure 244: Health check monitor
To create a health check monitor configuration
1 Go to Firewall > Virtual IP > Health Check Monitor > Create New.
Figure 245: Creating a health check monitor
2 Complete the following:
Create New Select to add a health check monitor configuration. For more information, see
“To create a health check monitor configuration” on page 394.
Name The name of the health check monitor configuration. The names are grouped
by the health check monitor types.
Details The details of the health check monitor configuration, which vary by the type of
the health check monitor, and do not include the interval, timeout, or retry,
which are settings common to all types.
This field is empty if the type of the health check monitor is PING.
Delete Select to remove the health check monitor configuration. This option appears
only if the health check monitor configuration is not currently being used by a
virtual server configuration.
Edit Select to change the health check monitor configuration.
Name Enter the name of the health check monitor configuration.
Type Select the protocol used to perform the health check.
•TCP
•HTTP
•PING
Port Enter the port number used to perform the health check.
This option does not appear if the Type is PING.
URL Enter the URL that will receive the HTTP request.
This option appears only if Type is HTTP.
Matched Content Enter the HTTP reply content that must be present to indicate proper server
connectivity.
This option appears only if Type is HTTP.
Interval Enter the number of seconds between each server health check.
To Next Page
Loading...