TO REMOVE SERVICE PANEL.
LIFT PANEL APPROX. 1/2" THEN
PULL BOTTOM OF PANEL OUT
AWAY FROM UNIT AND SLIDE
DOWN.
TO REMOVE FRONT PANEL. LOOSEN
WING BOLTS (CAPTIVE FASTENERS)
THESE ARE LOCATED ON THE INSIDE
OF THE CABINET. DIRECTLY BEHIND
THE UPPER LEFT AND RIGHT HAND
CORNERS OF THE FRONT PANEL.
ONCE THESE ARE LOOSENED. PULL
THE TOP OF THE FRONT PANEL
TOWARD YOU AND LIFT OFF OF
BASE. BE CAREFUL THERE IS A WIRING
HARNESS ATTACHED TO THE BACK
SIDE OF THE SWITCHES.
WING BOLTS BEHIND
FRAME
5000RT CUSTOMER SERVICE
PANEL AND FRONT REMOVAL
P-7
To Next Page
Loading...
