5. Installation
Figure 20: PRN
connectors
Connecting the Profinet Interface:
1. Connect a RJ45 cable to the PRN1 connector.
2. If necessary connect a RJ45 cable to the PRN2 connector.
5.4 Connecting the Power Supply
TIP
The measuring device has an integrated protection against
reverse polarity.
If the polarity of the power supply is incorrect, the measuring
device is protected against damage.
Figure 21: PWR
connector
Connecting the power supply:
1. Switch off the power supply.
2. Attach the cable of the power supply to the MC 1,5/ 2-
GF-3,81 connector.
Observe the pin assignments (+) and (-) on the PWR
connector.
3. Connect the MC 1,5/ 2-GF-3,81 connector to the PWR
connector.
4. Switch on the power supply.
46 / 76
MDE1195_4-10_1.3.x_5.0_Blackbird
OECD_(9CH, PRN)-en-us
© fos4X 2020
To Next Page
Loading...
Need help?
General