Foscam Huntvision - Local Area Network Access; Remote Access

12
Step 3. Access to your camera with DDNS address
hps://DDNS:HTTPS port No. (The default HTTPS port is 443)
For example: hps://****.myfoscam.org:443
3.2 Access to Camera via Foscam App
Now you can type in the DDNS address to get access to your camera, and the DDNS address would be:
You can have a easy access to your camera by using Foscam App from your smartphone. If you want to access
to your camera remotely, please make sure that your camera is connected to the Internet.
If you have added camera to your Foscam App, you just need to connect your smartphone and your camera to
a same network, and you can log in your camera in the App’s home page.
If you didn’t add camera to your Foscam App before, please check the Quick Start Guide for the detailed
instrucon on the method of adding your camera to Foscam App.
If you have added your camera to the Foscam App locally before and the camera has connected to the
Internet, then you can remotely access to your camera directly by using the Foscam App.
If you didn't add your camera to the Foscam App before, but the camera has already been setup, you can also
access the camera remotely by manually adding the camera with valid UID/WAN IP Address/DDNS, please
check the following steps to proceed it:
UID / WAN IP address / DDNS
NOTE: Before the following steps, please make sure that your camera is connected with the power adapter, and has been connected to a
router (or switch) with an Ethernet cable or WiFi which can access to the Internet.
3.2.1 Local Area Network Access
3.2.2 Remote Access