Four winns FUNSHIP - Forward.cover; Cockpit.cover; Mooring.cover; Trailering

Owner’s Manual Page 99Weather Covers - Section O
Figure O-5: Shock Cords
3. Snap the cockpit cover sides and rear (if appli-
cable) to the deck.
An adjustable pole is provided to adjust the canvas for
tautness.
F. Mooring Cover
Mooringcovers,availablefortheFunship™models,
are intended for longer term storage and spread over
the entire boat. If used in areas with snow accumula-
tion, be sure to support the canvas adequately and
inspect frequently for snow loads or damage will
occur. Refer to O-3 Winter Storage for additional
information.
To install:
1. Spread mooring cover over entire boat.
2. Install adjustable poles in bow area and in the rear
cockpit. Be sure the canvas is taut and no pockets
exist.
3. Tie off at the transom.
4. Nylon loops are provided for attaching rope or
bungie cords to the trailer or from side to side
(under the boat).
O - 2 TRAILERING
High winds encountered during trailering your boat
can severely damage most weather covers. If an
extended trip at highway speeds is planned, the top
and other weather covers should be in the down
position or removed entirely. This will prevent
damage and loss.
Figure O-4: Camper with Forward Bimini
Certain types of bimini/camper canvas are
designed for use while at rest only. Visibility is
greatly reduced when bimini/camper canvas
is deployed. Do not operate your Funship™
with this type of canvas fully deployed. See
Figure O-5. Remove and boot canvas prior to
beginning your cruise. Damage to canvas,
mounting hardware, boat and/or injury may
otherwise occur.
D. Forward Cover
TheforwardcoverisavailableontheFunship™
models. It is installed over the bow seating area and
is snapped to the deck and to the cockpit cover at the
walk-through. An adjustable pole is provided to adjust
the canvas for tautness.
E. Cockpit Cover
The cockpit cover is used to cover the complete
c
ockpit area and is intended as a short term storage
cover.ThecockpitcoverisavailableontheFunship™
models.
To install:
1. Snap the forward edge of the cockpit cover to the
walk-through on the windshield. Windshield snaps
will slide to adjust to the canvas.
2. Secure the rear corners.
a. If the canvas has snaps along the aft edge,
secure the corners.
b. If the canvas has shock cords along the aft
edge, attach to knobs as shown in
Figure O-5.