Four winns FUNSHIP - P-5 FIBERGLASS REPAIRS

Owner’s Manual Page 108Woodwork and Composits - Section Q
Figure Q-3: Refreshment Center Representation
Q - 6 ACRYLIC PLASTIC - (Plexiglass)
Acrylic plastic is utilized in most walk-thru doors,
windscreens, transom doors, portlight windows,
electrical panel doors and certain glove boxes.
To clean acrylic plastic:
1. Rinse with plenty of water to wash off as much dirt
as possible.
2. Using your bare hand, along with plenty of water,
feel and remove any dried-on dirt or mud.
3. Wash using a soft, grit-free cloth or sponge and
mild, nonabrasive soap or detergent.
4. Rinse thoroughly with water.
5. Blot dry using a clean, damp chamois.
NOTICE
Never use a dry cloth, duster, glass cleaning
solutions or citrus cleaner on acrylic plastic.
NOTICE
Do not use solvents such as acetone, silicone
spray, benzine, carbon tetrachloride, re ex-
tinguisher uid, dry cleaning uid, lacquer
thinner or ammonia. These solutions damage
the acrylic surface.
Youcanuseneautomotiveacrylicrubbingand
p
olishingcompoundstoremovenescratches
on acrylic. Always read the label before using any
product.