Four winns FUNSHIP - C. Battery Switch Operation

Owner’s Manual Page 67Electrical Systems - Section H
To avoid equipment damage or electrical res,
use only replacement fuses that are of equal
rating to the original fuse. Refer to the electrical
schematic included with this manual for proper
sizes.
Horn
- To sound the horn, push the HORN switch.
12 Volt DC Receptacle - Permits the use of additional
12 volt equipment such as a cell phone. Using the
appropriate adaptor, the equipment draws power from
the boat’s battery.
Aft Bilge Pump - The PUMP switch at the dash is
used to manually activate the bilge pump in the engine
compartment. The bilge pump is used to remove wa-
ter from the bilge (bottom of the hull) area of the boat
by pumping the accumulated water overboard.
On most Four Winns
®
models, the aft bilge pump is
equipped with an automatic bilge switch and will oper-
ate whenever bilge water rises above the pump stop
level.Thiswillcausetheinternaloattomoveupward
and activate the pump.
When leaving your boat unattended for an extended
period, check the charge on the battery(s) periodically.
Also check the water level in the bilge and make sure
theoatswitchisfunctional.
If the automatic bilge pump must be disabled,
disconnect the wiring plug near the bilge pump.
Bilge Blower- The BLOWER switch is used to
activate the bilge blower. The bilge blower is used to
remove any gas vapors that may have accumulated
in the bilge or engine areas.
Gasoline vapors can explode
resulting in injury or death.
Before starting the engine, check the engine
compartment bilge for gasoline or vapors.
Operate blower for four (4) minutes, and verify
blower operation. Run blower when vessel is
operating below cruising speed.
To verify blower is operating place your hand
over the vents. DO NOT rely on the sound
of the blower. Be sure a substantial amount
of air is being exhausted by the bilge blower.
Check the bilge blower system often,
preferably.
Navigation & Anchor Lights
- Moving the NAV/
ANC LTS switch towards the NAV position activates
the bow lights and the all-around light or both portions
of the mast light. Move the switch to the ANC position
to activate the all-around light or both the fore and aft
portion of the mast light. The center switch position
is OFF.
Wipers - The WIPER switch activates the windshield
wiper. This is an option for the starboard side only.
(NA on some models)
Accessories - Additional 12 volt equipment may be
added to the boat using an accessory switch. Certain
accessories may be wired directly to the fuse block
below the dash. For more information, refer to Section
H-3B Installation of Additional 12 Volt Equipment.
Cockpit Lights - The CKPT LTS switch is used to
activate the cockpit (courtesy) lights.
B. Installation of Additional 12 Volt Equipment
On the fuse panel, non-factory-installed 12 volt
accessory equipment can be connected to the “ACC”
(Accessory) terminal. Accessory equipment can also
be wired directly to a newly installed “ACC” switch
on the dash.