Franke F3D3SP Service Manual

F3D3 Series Service Manual Parts Replacement / Section 2.23
For Technical Support, Call 800-537-2653. Copyright  2012 Franke, Inc. All rights reserved.
2.23 Power Cord Replacement…Continued
18) From rear of unit – slide strain relief down on to threaded
grommet and tighten to secure power cord.
19) Position and secure rear service access panel and return
Dispenser to normal operating position.
Test Operation of new Power Cord:
22) Plug new power cord into power source.
23) Turn ON main power switch. Pilot light should come on,
and after a delay, the compressor should start and run.
[Photo 5]
Pull out power cord from right
plastic tubing then up through
grommet in condenser
compartment bottom.
Rev. 1 6/2012

Tools Required:
 Medium Phillips screwdriver
 Pliers or channel locks
 10 mm [3/8”] wrench
 Electric tape

Franke F3D3SP Specifications

General

Brand	Franke
Model	F3D3SP
Category	Dispenser
Language	English