PBA100 Rev0407
13
Install Engine Sensors
For most engines, the PumpBoss receives engine RPM, oil pressure, and coolant
temperature data over the J1939 databus. Some engines do not broadcast this data over
the databus and sensors may need to be installed.
Note: The PumpBoss may need a programming change for some sensor inputs
to be recognized. If the sensor was not ordered as part of the PumpBoss
kit you may need to contact FRC technical support for programming
information.
The sensors are wired to the 12-pin connector at the rear of the control module.
Refer to the Wiring section for pinout and wire color information.
An input is provided for an optional transmission temperature sensor.
Install Buzzer
Pin 6 on the 12-pin connector at the rear of the control module is provided to
connect an optional buzzer. Connect the ground side of the buzzer to pin 6. Maximum
current through pin 6 is 300 mA. The buzzer ordered from FRC requires a 1-1/8 inch
diameter mounting hole. (Refer to the Wiring section.)
Install High Idle Kit
The high idle is activated when + VDC is provided to pin 7 (High Idle Active
Input) of the 12-pin connector and pin 6 (Interlock Input) of the 8-pin connector. Refer
to High Idle Wiring.
Note: It is important that the connection to the Interlock Input from the High
Idle circuit be isolated from the apparatus interlock wiring with the two
diodes. The pump must NOT be engaged when using the high idle
function and the THROTTLE READY LED will be off.
To Next Page
Loading...
