FRC PumpBoss PBA100 - 8-Pin Connector Wiring

PBA100 Rev0407
25
Figure 5. PBA 8-Pin Connector Wiring
Notes:
- Not all wires are used for all engines. Refer to the engine specific wiring diagram
for interface connections.
- An adapter and cable assembly replaces the basic 8-pin cable when connecting the
ThrottleXcel to a Ford or GMC engine. Refer to the engine specific wiring diagram.
Control Module
Rear View
8-Pin
Connector
Pin 1
12-Pin
Connector
Pin 1
Vent
8 Pin Connector/Cable
Pin Wire Color Description
1 Red Supply Voltage (12/24 VDC)
2 Black Ground
3 Orange +5 VDC Reference From ECM
4 White Throttle Signal To ECM
5 Green Signal Return From ECM
6 Yellow Interlock Input (+ VDC)
7 Blue Throttle Enable Signal Output
8 Brown Foot Pedal Signal Input
8-Pin Cable
RED
BLK
ORG
WHT
GRN
YEL
BLU
BRN
8-Pin
Deutsch
Connector
Butt
Connectors
12/24
VDC
Ignition Key
+ VDC
Pump Engaged
Interlock
GND