FRC PumpBoss PBA100 - Table 2. Error Codes; Table 3. Fault Warning Codes

PBA100 Rev0407
15
Table 2. Error Codes
Table 3. Fault Warning Codes
RPM
Display
Message
Display
Probable Cause
E01 NO DATA
>Datalink cable not connected / connected to wrong port
>Broken wire / bad connector contact on datalink cable
E02 NO RESP
>No responce to control signal
E03 NO RPM
>Datalink cable not connected / connected to wrong port
>Engine not running / ignition key on
>Broken wire / bad connector contact on alternator cable
E04 N/A
N/A
E05 NO PSR
Pressure sensor not detected
E06 N/A
N/A
E07 N/A
N/A
E08 Trans
>Sensor cable not connected
>Broken wire / bad connector contact on sensor cable
>Defective temperature sensor
E09 ENG OIL'
>Sensor cable not connected
>Broken wire / bad connector contact on sensor cable
>Defective pressure sensor
E10 ENG T'
>Sensor cable not connected
>Broken wire / bad connector contact on sensor cable
>Defective temperature sensor
RPM
Display
Message
Display
Description
F01 -
N/A
F02 -
N/A
F03 HI RPM
High Engine RPM
F04 -
N/A
F05 PRES LOW
Pump Cavitation
F06 HI BATT
High Battery Voltage
F07 LOW BATT
Low Battery Voltage
F08 Trans 'T
High Transmission Temperature
F09 LOW OIL
Low Engine Oil Pressure
F10 ENG TEMP
High Engine Coolant Temperature