FRC PumpBoss PBA100 - Ford Torque Lock-up Module

PBA100 Rev0407
33
Green wire will go low when the engine
RPM goes above the program third gear
lock-up setting.
From Adapter Assembly 8-Pin
Connector Green Wire (Pin 7)
FRC Torque
Lock-up Module
Black
Wire
Red
Wire
+12 VDC
GND
White
Wire
Blue
Wire
Green
Wire
Brown/Orange
Wire
To PCM
Pin 14
Locate the Brown/Orange trace wire,
Circuit 12A650, in the harness bundle
that passes over the transmission.
To Transmission
Torque Converter
Pin 8
(C1385 Torque
Converter Clutch
Solenoid)
Ford Torque Lock-up Module
The torque lock-up module is used with automatic transmissions to provide a third
gear lock-up signal. An output from pin 7 (green wire) on the adapter assembly will
contol the Torque Lock-up Module The RPM for the green wire to go low and engage
the third gear lock-up is factory set. If this setting needs to be changed, contact FRC.
Figure 13. Ford Torque Lock-up Module Wiring