PBA100 Rev0407
34
Scania Harness Connections
Interface Information
For use on P, R, and T-series trucks equipped with a bodywork control unit (BWS).
Connector C259 is available on all vehicles ordered with any of the bodywork options. It
is located on the plate for the electrical bodywork interface for body builders. Connector
C259 is white and has 21 pins. (February 2005 and newer.)
Figure 14. Scania PBA108-B Wiring
12 15 18 21
Contact Housing (MCP)
C259
3 6 9
12-Pin
Connector
(Refer to
Figure 4)
8-Pin
Connector
(Refer to
Figure 5)
C259
Connector
8
Engine RPM Control 2 +24 Volts
Blue Wire
CAN high
Red Wire
21
Green Wire
9
Engine RPM Control 2 Earth
11
10
Engine RPM Control 2 Signal
Engine RPM Control 2 +5 Volts
Orange Wire
White Wire
CAN low
Black Wire
20
Note: Signal to pin10 is 0.6 to 3.0 V
Note: Refer to Figure 5. PBA 8-Pin Connector Wiring
for power and interlock wire connections.
The EXT switch must be
in the ON position when
operating the PumpBoss.
To Next Page
Loading...
