Control Solution Results
Compare the control solution result to the
range printed on the test strip instructions
for use. The result on your screen should be
in this range.
Control solution results are marked on
the results screen and in the Logbook
with a
symbol.
Note: Repeat the control solution test if the results are
outside of the range printed on the test strip instructions
for use. Stop using the built-in meter if the control solution
results are repeatedly outside of the printed range. Contact
Customer Service.
100
mg
dL
10:23pm
Control Solution Test
Example Screen Only
Charging the Reader
A fully charged Reader battery should last up to 7 days. Your battery
life may vary depending on your usage. A Low Battery message
accompanies your result when you have enough charge remaining for
about one day of use.
Plug the included USB cable into an electrical
outlet using the included power adapter. Then,
plug the other end of the USB cable into the USB
port on the Reader.
Notes:
• You must charge the Reader when the battery
is low
to keep using the Reader.
• To fully charge the battery, charge the Reader
for at least 3 hours.
• Only use the USB cable and power adapter
included with the system.
• Fully charge your Reader before storing it for
more than 3 months.
Charging
CAUTION: Be sure to select a location for
charging that allows the power adapter to be
easily unplugged. Don’t block access to the
charger due to the potential risk of electrical
shock.
75 76
ART38553-101_rev-A_manual.indd 75-76 2/1/18 2:13 PM
To Next Page
Loading...
