Display What It May Mean What To Do
New Sensor
Found
You scanned a new
Sensor before your
previous Sensor
ended.
Your Reader can only be used
with one Sensor at a time. If
you start a new Sensor, you will
no longer be able to scan your
old Sensor. If you would like to
begin using the new Sensor,
select “Yes”.
Scan Error The Reader
was unable to
communicate with
the Sensor.
Try scanning again.
Note: You may need to move
away from potential sources of
electromagnetic interference.
Sensor Error The System is
unable to provide a
glucose reading.
Scan again in 10 minutes.
Display What It May Mean What To Do
Glucose
Reading
Unavailable
Your Sensor is too
hot or too cold.
Move to a location where the
temperature is appropriate and
scan again in a few minutes.
Sensor
Already in
Use
The Sensor was
started by another
Reader.
A Sensor can only be scanned
by the Reader that started it.
Scan the Sensor again with the
Reader that started it. Or, apply
and start a new Sensor.
Check Sensor The Sensor tip may
not be under your
skin.
Try to start your Sensor again. If
Reader displays “Check Sensor”
again, your Sensor was not
applied properly. Apply and
start a new Sensor.
Replace
Sensor
The System has
detected a problem
with your Sensor.
Apply and start a new Sensor.
91 92
ART38553-101_rev-A_manual.indd 91-92 2/1/18 2:13 PM
To Next Page
Loading...
