June 2022 revisions
Throughout – Added HPS 407 models in body text where relevant
Cover – Added 407 model image
Page 3 – Updated Standard bare compressor
Page 4 – Added 407 info to nomenclature example
Page 5 – Split
table 1
from previous revision into four tables, which are now
Table 2 to Table 5
– Updated Preparing the compressor for storage section
Page 6 – Updated HPS 273 and 407 compressors section
Page 7 – Updated Volumizer variable volume ratio control section
– Added Balance piston oil requirements and regulation section;
– Updated Oil pump, optional
Page 8 – Updated Design limits section
– Updated Figure 5
– Updated Balance piston
Page 11 – Added Lifting instructions
Page 12 – Added weight info to Foundation section
Page 13 – Updated Customer connections section
– Added Figure 8
Page 14 – Added Oil system
– Removed unnecessary info from Oil pump section
– Updated notice
– Updated Oil cooling requirements
Page 15 – Added Compressor hydraulic system section
Page 16 – Added Figure 9
Page 17 – Added warning in Operation and start-up instructions section
– Added warning in Ambient temperature effect on compressor opera-
tion section
– Updated Before starting up the compressor section, including sub-
sections
Page 18 – Updated Initial start-up procedure section, including subsections
Page 21 – Added rst and second warnings in General information
– Added note in Changing oil
Page 22 – Updated Maintenance schedule
– Added 4009/4012 info to Table 9
Page 24 – Added Replacing the capacity linear transmitter: slide valve section
Page 29 – Added Figure 12
January 2021 revisions
Throughout – Removed HPSH nomenclature and changed to HPS
– Updated Frick and JCI logos
Page 3 – Updated Figure 1
Page 4 – Updated Figure 2
– Updated m
3
/h (cfm) conversion in
Table 1
Page 5 – Updated Preparing the compressor for storage section
– Added callout table for Figure
– Updated psig conversion in Maintaining the compressor in storage
Page 6 – Updated Bearings section
Page 7 – Updated Shaft seal section (removed last sentence)
Page 9 – Added callout table for Figure
Page 11 – Updated port information on Customer connections section
– Added callout table for Figure
Page 16 – Updated Table 9
– Removed spare parts table
Page 22 – Updated Figure 10, port SL-0 changed to SC-7
Johnson Controls
100 Cumberland Valley Avenue
Waynesboro, PA 17268-1206 USA
Phone: 717-762-2121 • FAX: 717-762-8624
www.johnsoncontrols.com/Frick
Form 070.755-IOM (2022-06)
Supersedes: 070.750-IOM2 (2021-01)
Subject to change without notice
Published in USA • 06/22 • PDF
© 2022 Johnson Controls - All Rights Reserved
To Previous Page
Loading...
