11
Wall Controller Installation
Installing the Wireless Receiver
Mount the Receiver as high as
possible. It MUST be higher than
the VRP unit (top)
To maximize the wireless signal
strength from the Receiver to the
VRPXEMWRT2 Wall Controller,
the Receiver MUST NOT be
installed on the VRP unit.
Note: Depending upon the closet size, an appropriate length of Field Supplied
CAT 6 cable will be required.
VPXEMWRT2-Thermostat Manual_pkg.indd 11 2017-12-15 3:37 PM
To Next Page
Loading...