10
Installing the Wireless Receiver
• Unplug the VRP
®
unit from power supply.
• Connect the low voltage wires to screw terminals on the VRP
®
unit low
voltage terminal block - refer to the Wiring Table to determine proper
connections.
• Ensure that the Wireless Receiver antenna is not touching any metal
components of the VRP
®
unit.
• Ensure that the Wireless Receiver antenna is facing the Wall Controller
on the wall and is oriented so that any metal parts of the VRP
®
unit do not
obstruct the wireless communication to the Wall Controller and, in case of a
network installation, to other wireless Receivers and the server.
• Plug the VRP
®
unit to power supply.
Wall Controller Installation
Receiver
VPXEMWRT2-Thermostat Manual_pkg.indd 10 2017-12-15 3:37 PM
To Next Page
Loading...