Friedrich VRPXEMWRT2 - Testing the Wall Controller

19
Testing the Wall Controller
Following the Wall Controller conguration, test if the Wall Controller is controlling
the VRP unit.
• Press the “Power” button to turn the Wall Controller ON;
• Press the “Up” and “Down” buttons to change the temperature set point
above and below the current room temperature to test if the Wall Controller
initiates heating and cooling - the VRP unit should turn heating and air
conditioning on and off.
• Change the fan speed by touching “Fan” button to test if the Wall Controller
is controlling the fan speed.
Wall Controller Conguration
VPXEMWRT2-Thermostat Manual_pkg.indd 19 2017-12-15 3:37 PM