Friedrich VRPXEMWRT2 - Custom Energy Savings Settings

To Next Page

To Previous Page

Custom Energy Savings Settings

If you don’t want to use the one of the energy saving presets detailed in the

Appendix 1, you can enter the custom energy savings settings.

Accessing the Wall Controller Settings

• Press and hold the “Conguration” button until the rst Wall Controller

settings screen appears.

The Wall Controller must be turned on to access the Wall Controller settings.

NOTE: If the Wall Controller is connected to a network, the equipment and the

energy saving settings congured on the Wall Controller will be ignored and the

settings congured on the Remote Management Website will be applied

NOTE: You can access Wall Controller Settings by pressing and holding the

“Conguration” button.

CONFIGURATION

BUTTON

VPXEMWRT2-Thermostat Manual_pkg.indd 20 2017-12-15 3:37 PM