Friedrich VRPXEMWRT2 - Wall Controller Wiring Installation

12
Wall Controller Wiring Installation
There are four sets of connections for the VRPXEMWRT2 Wall Controller. The
supplied cable from the VRPXEMWRT2 Receiver as shown in Figure 1, has four
color coded wires. Each of these wires must be connected to two Cat6 wires as
shown in Figure 2. Each connection is made with a lever type connector. Four
connectors will be needed to complete unit wiring. Each connector is capable of
connecting three wires.
Figure 1
Figure 2
WIRE COLOR LABEL
Orange
Connection 1
V+
Orange
Green/White
Brown
Connection 2
D+
Brown
Blue/White
Blue
Connection 3
D-
Blue
Brown/White
Green
Connection 4
V-
Green
Orange/White
Ground Shield
Wire
GND
VPXEMWRT2-Thermostat Manual_pkg.indd 12 2017-12-15 3:37 PM