The ‘Recharge Battery’ level has a higher priority in the power management system than ‘Time
Completed’ for the obvious reason that the Power Pack voltage is at a lower level. For this reason,
immediately following a ‘Recharge Battery’ message the RoboMower will emit a buzzer sound every 30
seconds for the next 20 minutes in order to alert you that the mowing session is completed and it is now
time to re-connect the Power Supply to the RoboMower. If the RoboMower is not connected to the Power
Supply within the next 21 hours, a higher-level alarm will sound. If the Power Supply is still not connected
after this alarm series, the mower will enter a deep sleep mode to conserve power. If the RoboMower
enters a deep sleep mode, the Power Pack must be removed for 10 seconds and then re-inserted in order
to wake up the RoboMower. However, if the mower reaches this level and the Power Supply is not
connected soon, you risk causing poor performance and service life to the Power Pack.
Similar alarms will alert you to connect the Power Supply if not connected after a fixed time, when
operating under fixed run-time settings. Lastly, if the Power Supply is disconnected, even after the fully
charged message, the alert system will operate to remind you to keep the Power Supply connected until
ready to use for mowing.
5.5 Off-season storage
When preparing the RoboMower for off-season storage, first fully charge the Power Pack and then store it
separately from the RoboMower in a dry location where the temperature will not drop below -20 ºC (-4ºF).
Recharge the Power Pack every three months while in storage.
Important! For more details regarding the winter storage please refer to section 9.8.
50
To Next Page
Loading...
