Weekly program
Press GO
Time: Mo 10:35
Press GO
Press ‘GO’
Docking options
Press GO
Entry points
Press GO
Auto depart on
Press GO
Skip next depart on
Press GO
Weekly program
Press GO
Time: Mo 10:35
Press GO
Press ‘GO’
Docking options
Press GO
Entry points
Press GO
Auto depart on
Press GO
Skip next depart on
Press GO
6.4 Docking Options (for Charging Station only)
Pressing ‘GO’ at the ‘Docking options’ display will open the option to scroll between the following
menus (Figure 6.9):
For more details about the ‘Time’ and ‘Weekly program’ settings, see chapter 4.1 and 4.2.
Figure 6.9
Charging Options
Set entry points
Pres GO to learn
Back to default
Press GO
Entry points on
Press GO
Entry Points
Press GO
Press ‘GO’Press ‘GO’
6.4.1 Entry Points
‘Entry points’ are defined as the points, where the mower leaves the Edge and turns into the lawn to
mow the inner area. In order to ensure better area coverage in mowing, the mower has a default of
three different entry points: at the Charging Station, 30% and 60% of the perimeter length.
RoboMower uses the 3 default entry points in cyclic mode and it is not possible to set entry point per
specific day. The ‘Entry points’ option enables to set different entry points from those set by the
factory to your lawn and to set the entry point you want per scheduled day.
Under the ‘Entry points’ display you can find the following three options (figure 6.10):
Set Entry Points
It is possible to set up to four points (includes the Charging Station itself, which is always defined as
entry point number one and cannot be cancelled).
Place the mower in the Charging Station when the Manual Controller in its place and follow the steps
below (Figure 6.12) in order to set the Entry Points:
Figure 6.10
56
To Next Page
Loading...
