Message
Displayed
Probable Cause/Event
Corrective/User Action
Skipped: Low
bat
- RoboMower has skipped the last depart due to low
battery voltage
- Confirm there is enough time between the two
adjacent departures so the battery can be
charged prior the scheduled operation (min 16
hours between operations)
Skipped: Rain
(Only Enhanced
Manual
Controller)
- RoboMower has skipped the last depart due to rain
detection
- It is not recommended to cut wet or damp
grass, but if you choose to override the rain
sensor, change the setting of the ‘Rain sensor’
to ‘off’ under the ‘User preferences’ menu.
- An unknown fault has occurred and user help is
required
- Manually drive the mower away from this
particular area and restart operation
Start Elsewhere
- Wheel drive motors have been working under a
severe load
- Check to insure the mower is not stuck,
allowing the wheels to slip
Thermistors fail
- Faulty / disconnected thermistors (overheat
protection)
- Contact service provider
Time Completed
- The operating time set for that zone has been
reached
- Connect to the charger if all mowing has been
completed for the day.
Waiting for
signal…
- RoboMower has stopped the operation in Dock
zone, because there is no signal received from the
Charging Station
- Check the power to the Charging Station.
- There is electrical power interruption. There is
no need to do anything – RoboMower will
renew automatically the operation if the power
will come back within an hour from the break.
7.2 Other Operational or Fault Problems
Problem Encountered
Probable Cause/Event
Corrective/User Action
- In general, every time the mower does not depart at the scheduled time it is recorded
under the ‘Weekly Program Display’
(refer to section 4.4 for more details).
- Confirm the time in the mower is set
correctly (day and hour)
- Set the time (See paragraph 4.1)
- Low battery voltage
- Confirm there are minimum 16 hours of
charging in the Charging Station before the
next scheduled depart
RoboMower does not leave
the Charging Station for
operation at the time set in the
Weekly Program
- ‘Auto depart’ is set to ‘off’ (‘Manual
depart’ is displayed when the mower
is in the Charging Station)
- Change the setting of the ‘Auto depart’ to ‘on’
(See paragraph 6.3)
RoboMower does not detect
the Charging Station contacts
and/or ‘Front wheel problem’
is displayed when the mower
is in the Charging Station
- Power supply/charger is not
plugged into the main power supply
- Confirm power supply is plugged into the main
power receptacle.
RoboMower reached the
Charging Station when its
contacts are above the
Charging Station contacts
- Height difference between the
Charging Station base and the lawn
surface at the entrance to the
Charging Station
- Confirm the ground before the Charging
Station is leveled with the Charging Station
base – if necessary fill the area with dirt and
level off
RoboMower does not
complete the edge in plot with
Charging Station
- RoboMower has performed short
distance edge and keep it in
memory
- Choose ‘Back to default’ option under the
‘Entry points’ menu (it will delete the edge
distance from the memory)
62
To Next Page
Loading...
