Message
Displayed
Probable Cause/Event
Corrective/User Action
Low battery
- Mower is searching for the Charging Station but the
battery voltage is too low to continue the searching
process
- Drive the mower manually for charging in the
Charging Station
Low temp.
Disc. charger
- RoboMower is charged through the plug and
ambience temperature is out of range (below 32 ºF
/ 0 ºC); disconnect the charger plug from the
RoboMower.
- RoboMower charging is not allowed when the
ambience temperature is going down below
32ºF / 0ºC; Disconnect the charger plug and
wait until the temperature will go down or take
the RoboMower to be charged in a warmer
place.
Low battery
- Mower is searching for the Charging Station but the
battery voltage is too low to continue the searching
process
- Drive the mower manually for charging in the
Charging Station
Low temp.
Disc. charger
- RoboMower is charged through the plug and
ambience temperature is out of range (below 32 ºF
/ 0 ºC); disconnect the charger plug from the
RoboMower.
- RoboMower charging is not allowed when the
ambience temperature is going down below
32ºF / 0ºC; Disconnect the charger plug and
wait until the temperature will go down or take
the RoboMower to be charged in a warmer
place.
Low temp.
Waiting…
- RoboMower is charged through the Charging
Station and the ambience temperature is out of
range (below 32ºF / 0ºC);
- Do not do anything, the charging is stopped
and RoboMower is waiting for temperature to
change back to the allowed range; if
temperature stays out of the range for more
than 12 hours, the message is changed to
‘Low temp. Press GO’.
Left/Mid/Right
mow problem
- Mowing motor is faulty or disconnected - Contact service provider
Move from Wire
- The RoboMower is positioned too close or on top of
the perimeter wire
- Move the RoboMower approximately 6 – 10
feet (1.5 – 3m) away from the perimeter wire
and start again.
Mowing
Overload
Cooling, Wait
- The mowing motors have been working under a
severe load for too long of a time.
- There is no need to do anything – RoboMower
will renew automatically the operation, as the
mowing motor will cool down.
No Wire Signal
- Perimeter Switch is not turned on or not connected
to the zone intended to mow
- Make sure the Perimeter Switch is connected
to the correct zone and is turned on
Rain detected
Go to ignore
(Enhanced
Manual
Controller only)
- RoboMower detects rain upon GO pressing
- Do not operate RoboMower in rainy weather
and wet grass; If you choose to override,
press the GO button; The overriding is valid
for the current operation only
Ready
Keep Charging
- The battery is fully charged
- Keep the charger (power supply) connected
and operating
Recharge
Battery
- The maximum operating time has been reached - Connect the charger to the mower
Replace blades
every 200 hours
- An automatic reminder to replace the blades is
displayed every 200 hours
- Replace the blades and restart the counter of
the blades replacement reminder by choosing
the ‘Blades replaced – Clear reminder’
option under the ‘User Preferences’ menu
Replace lamp
- The Operating Lamp is burnt out
- Confirm the message and replace the
Operating Bulb as soon as possible
Retry elsewhere
- Calibration failure from interference in the
immediate area
- Move the RoboMower 10-12 feet (3-4m) from
this spot and attempt calibration again.
Set Country
- Displayed only on first use. - Follow prompts on LCD screen to set country
Set Time
- Displayed every time the power pack is taken out of
the mower (reset operation)
- Set real time clock (day and hour)
61
To Next Page
Loading...
