Message
Displayed
Probable Cause/Event Corrective/User Action
- The mower contacts do not touch the Docking
Station contacts
- Make sure that both mower drive wheels are
leveled with the Docking Station base (if
necessary fill the area underneath the drive
wheels with dirt)
- The mower or Docking Station contacts are dirty
- Clean the contacts with a brush or piece of
cloth
- Charging is not detected, although there is physical
contact between the mower and the Docking
Station contacts (mower is found in the Docking
Station entrance).
- Turn on the Perimeter Switch
- Confirm a good connection of the cables to the
Docking Station contacts.
- Check the Charging fuse 5A (remove the
plastic cover below the Manual Controller).
Docking problem
- Mower does not reach the Docking Station within
the time and distance limitations.
- Confirm the mower is operated in a docking
zone.
- Confirm the mower is not slipping or stuck on
its way to the Docking Station.
Drive Overload
Cooling, Wait…
- The drive motors have been working under a
severe load for too long.
- There is no need to do anything – RoboMower
will renew automatically the operation, as the
drive motor will cool down.
Drive problem
- Internal failure - Contact service provider
Enter Code
- The theft guard system is activated
- Enter the correct 4-digit code. ‘Theft Guard’
can be deactivated under ‘User Preferences’.
Contact your service provider for assistance in
a lost code situation.
Front/Rear
bumper disc.
- Internal bumper failure - Contact service provider
Front/Rear
bumper pressed
- Front or Rear Bumper is constantly being pressed
- Move mower away from object pressing
against bumper.
CAUTION – Remove power pack before lifting
the mower
- The RoboMower has driven onto an obstacle,
raising the front end. Remove or exclude this
object from the mowing area.
- The RoboMower is being used on a slope too
steep for safe mowing. Exclude this from the
mowing area.
- High grass is preventing the front wheel from
fully riding on the ground. Raise the cutting
height.
Front Wheel
Problem
- The Front Wheel has left the ground for more than
8 – 10 seconds.
- The ground contains large holes or indentions
where the front wheel can drop into when
passing across. Fill these areas with dirt and
level off.
High temp.
Disc. charger
- RoboMower is charged through the plug and
ambience temperature is out of range (above 158ºF
/ 70ºC)
- RoboMower charging is not allowed when the
ambience temperature is raised above 158ºF /
70ºC; Disconnect the charger plug and wait
until the temperature will go down or take the
RoboMower to be charged in a cooler place.
High temp.
Waiting…
- RoboMower is charged through the Charging
Station and the ambience temperature is out of
range (above 158ºF / 70ºC);
- Do not do anything, the charging is stopped
and RoboMower is waiting for temperature to
change back to the allowed range; if
temperature stays out of the range for more
than 12 hours, the message is changed to
‘High temp. Press GO’.
Keep charging if
not used
- Message is displayed every time the charger plug is
disconnected from the mower.
- Displayed when the mower isn’t in operation and
not connected to the charger/Charging for a long
time.
- Press any key to change the display back.
- Send the mower back to the Charging Station
for charging / connect the charging plug or
continue in operation
Keys locked
- Child lock feature has been activated
- Press the Up ⇑ arrow key and then press the
‘C’ button. Child lock can be deactivated
under User preferences.
60
To Next Page
Loading...
