Problem Encountered
Probable Cause/Event
Corrective/User Action
- Batteries are completely
discharged.
- Install fresh alkaline C-cell batteries
- Batteries installed with wrong
polarity position.
- Verify correct placement of batteries.
Perimeter Switch will not
activate when turned on.
- Perimeter Switch not installed
vertically and exposed to water/rain.
- Water/moisture protection of the Perimeter
Switch can only be insured when mounted
vertically. Replace Perimeter Switch.
- Mower is in deep sleep.
- If not connected to the charger at all times
when not in use, the RoboMower will conserve
power by entering into a deep sleep mode. Lift
Power Pack from mower and re-insert it after
10 seconds.
RoboMower will not operate
and nothing will display on the
LCD screen.
- Power Pack has been discharged
from lack of charge maintenance.
- It is required for the charger to remain
connected to the RoboMower when not in use.
Failure to do so can cause permanent Power
Pack damage. Contact your service provider.
RoboMower drives but blades
will not mow.
- ‘Mowing ‘has been turned to off. - Change back on under ‘User Preferences’
- Power Pack is not fully charged
- Connect the charger to the mower and keep it
connected until the ‘Ready – Keep Charging’
message displays in the LCD screen.
- ‘Work Time ‘ for that zone is set to
stop at a pre-determined duration.
- Work time can be changed under ‘User
Preferences’
- Grass is extremely over grown or
very wet.
- Raise cutting height. Always mow the grass
frequently enough to prevent over growth.
Refrain from cutting wet grass.
- Power Pack is reaching a normal
end of life state.
- Replace Power Pack. Properly maintain Power
Pack per instructions.
Short run time, operates less
time than normal.
- Manual Controller is not firmly
pivoted down flush in holder,
allowing it to bounce up and stop the
mower.
- Confirm the coiled cord is fully placed into the
holder below the Manual Controller and the
Manual Controller closes flush with the top of
the mower.
RoboMower has crossed over
wire during operation
CAUTION
The RoboMower is designed
to remain within an active
perimeter of your lawn when
properly installed. In the
unlikely event that the mower
does cross over the wire, DO
NOT use the mower until the
problem is corrected. If
changing the perimeter wire
placement does not correct
this problem, contact you
service provider.
- Improper perimeter wire setup OR
adjacent zone (closer than 13 feet /
4 m) operated simultaneously.
- Refer to the setup rules for wire placement,
particularly for corners. Do not operate
adjacent plots simultaneously when closer than
13 feet (4 m).
64
To Next Page
Loading...
