Address: Room 1705,Block A1, Longyuan Plaza, Longkouxi Road, Guangzhou, China, 510640 Website: http://www.arm9.net
Sales: +86-20-85201025 Tech Support: +86-13719442657 Fax: +86-20-85261505
Email for Business and Cooperation: capbily@163.com Email for Tech Support: dev_friendlyarm@163.com
You can configure the HDMI setting in the “/root/Settings/HDMI.conf” file.
[HDMISetting]
AutoStart = yes
Resolution = 720P-60Hz
SupportResolution1=720P-60Hz
SupportResolution2=1080I-50Hz
“AutoStart” defines whether the HDMI output will be started on system boot.
“Resolution” defines the HDMI resolution and the following values are available:
1080P-60Hz, 1080P-50Hz, 1080I-60Hz, 1080I-50Hz, 720P-60Hz, 720-50Hz,
576P-50Hz-16:9, 576P-50Hz-4:3, 480P-60Hz-16:9 and 480P-60Hz-4:3
HDMI’s backend service is “hdmi-service” which can be started by calling
“hdmi-service autostart” in the “/etc/init.d/rcS”.
7.2.6 HDMI Output Without Connecting LCD
The 210 boards can output to HDMI monitors without connecting an LCD.
If you want to connect your 210 board only to an HDMI monitor without connecting
an LCD you need to specify “LCD-Type” e.g. “LCD-Type=HDMI720P60”. You need to
reflash your board with this new definition without connecting an LCD.
After an OS is installed please power on the board without connecting an LCD you
will be able to see HDMI output.
7.2.7 Play MP3
Go to the “Application” page, click on the “music” icon, select an mp3 and click on
“play”.
To Next Page
Loading...
