Address: Room 1705,Block A1, Longyuan Plaza, Longkouxi Road, Guangzhou, China, 510640 Website: http://www.arm9.net
Sales: +86-20-85201025 Tech Support: +86-13719442657 Fax: +86-20-85261505
Email for Business and Cooperation: capbily@163.com Email for Tech Support: dev_friendlyarm@163.com
1. Please flash the superboot to an SD card with “SD-Flasher”
2. Please copy the whole “images” directory from your DVD to the root directory of
your SD card
3. Open the “images/friendlyARM.ini” and add the following line
USB-Mode = yes
Please follow the steps below to connect your board to your PC
1. Switch the S2 on your board to “SD”
2. Power on the board and you will see the LCD showing “USB Mode:Waiting” if
everything works correctly
3. Please connect your board to your PC via a USB cable
4. If the connection is successful the LCD will show “USB Mode:Connected”
Now you can start installing systems with the Minitools
To change the installation method back to SD card installation you just need to
change the “USB-Mode = yes” to “USB-Mode=no”.
4.3.3 Install Systems with Minitools
Please enter the USB download mode and connect your board to your PC which runs
the Minitools via USB
To Next Page
Loading...
