Frigomat CHEF 30 LCD - Troubleshooting Guide; Alarm Management and Remedies

ENGLISH
-
58
8. INSTRUCTIONS FOR TROUBLESHOOTING
8.1 MANAGEMENT OF ALARMS
MESSAGE DESCRIPTION REMEDIES
ALARM!
EMERGENCY HATCH
OPEN
The cover is open or a safety device which stops
the beater is active.
The buzzer emits an intermittent acoustic signal.
Make sure that the cover is closed
and positioned properly.
ALARM!
INSUFFICIENT FLUID
LEVEL
The level of the glycol is insufficient.
The buzzer emits an intermittent acoustic signal.
Contact the technician to check the
level of the glycol in the tank and
to see if the circuit leaks.
ALARM! MOTOR
CIRCUIT BREAKER
OVERLOAD
A motor circuit breaker, the boiler safety
thermostat or the transformer fuse has
intervened.
The buzzer emits an intermittent acoustic signal.
Wait a few minutes and then press
STOP to restore machine
operation.
If the alarm continues, contact the
technician.
ALARM! TEV PROBE
INTERRUPTED
The TEV probe is faulty.
The buzzer emits an intermittent acoustic signal.
Contact the technician for check
and replace the faulty probe.
ALARM! TEF PROBE
INTERRUPTED
The TEF probe is faulty.
The buzzer emits an intermittent acoustic signal.
Contact the technician for check
and replace the faulty probe.
ALARM! TEC PROBE
INTERRUPTED
The TEC probe is faulty.
The buzzer emits an intermittent acoustic signal.
Contact the technician for check
and replace the faulty probe.
ALARM! TEV PROBE
SHORT CIRCUIT
The TEV probe is faulty.
The buzzer emits an intermittent acoustic signal.
Contact the technician for check
and replace the faulty probe.
ALARM! TEF PROBE
SHORT CIRCUIT
The TEF probe is faulty.
The buzzer emits an intermittent acoustic signal.
Contact the technician for check
and replace the faulty probe.
ALARM! TEC PROBE
SHORT CIRCUIT
The TEC probe is faulty.
The buzzer emits an intermittent acoustic signal.
Contact the technician for check
and replace the faulty probe.
ALARM! CHECK THE
CONNECTION WITH THE
INVERTER
The inverter connection with the circuit board is
faulty or interrupted.
Call the technician to check the
connection between inverter and
circuit board.
ALARM!
INVERTER KO
The inverter is faulty or in alarm condition.
Call the technician to check correct
inverter functioning.