- COOLING (to 1°C)
After having programmed the stand-by time, it is
possible to set the cooling temperature of the
product in the tank.
Press “UP” and “DOWN” keys to increase or
decrease the cooling temperature value.
Press “OK” to confirm the data and pass to
programming the next item.
To prevent programming errors by the users, it is
possible to select only cooling temperatures lower
than the heating temperature programmed
previously
- BEATER (from S1 to S10)
After having programmed the cooling temperature,
it is possible to set the mixing speed.
Press “UP” and “DOWN” keys to increase or
decrease the mixing speed value.
Press “OK” to confirm the data and pass to
programming the next item.
Programming the mixing speed operated by the user, is used by the machine with different
modes depending on the previously-set heating temperature, both higher and lower than
70°.
- If the heating temperature has been programmed at a value higher than 70°, the
machine uses the speed programmed by the user only for heating temperatures
exceeding 70°, during the entire stand-by and in the next cooling phase to 30°.
- However, if the heating temperature has been programmed at a value lower than 70°,
the machine uses the speed programmed by the user during the entire heating phase,
in the stand-by and in the next cooling phase to 30°.
In both cases, in the cooling phase, on exceeding 30°C the speed automatically switches
to S1.
To Next Page
Loading...
