Fromm AP250 - Machine Settings and Adjustments; Adjusting Pillow Perforation; Adjusting Air Pillow Filling

17
50302501manen.f
Copying all or part of this manual in any way or form is prohibited without prior written consent from its author. © 2012
website: www.fromm-pack.com
19 POSSIBLE MACHINE SETTINGS
19.1 Adjusting perforation
If the air pillows are too perforated or not perforated enough, the cutter height may be adjusted.
This value may be modified only when the machine is stopped.
After approximately 30 seconds without changing the value, the display will automatically return to the main
menu.
19.2 Adjusting filling
If during the production cycle, the air pillows are too full or not filled sufficiently, the fan speed may be adjusted.
This value may be modified only when the machine is stopped.
After approximately 30 seconds without changing the value, the display will automatically return to the main
menu.
Press the button
Then press 3
(on the keypad)
The value will flash.
Use the up and down arrows
Use the up and down arrows (on the
keypad) to change the value.
The available range is from -20 to
20.
Press the button to confirm
The new value has been saved.
Press the button
Then press 4
(on the keypad)
The value will flash.
Use the up and down arrows
Use the up and down arrows (on the
keypad) to change the value.
The available range is from -5 to 5.
Press the button to confirm
The new value has been saved.