9
50302501manen.f
Copying all or part of this manual in any way or form is prohibited without prior written consent from its author. © 2012
website: www.fromm-pack.com
12 MOVING THE UNPACKED MACHINE
Do not stand under hanging loads.
Be especially careful with hanging parts, and the risks that may stem from these parts.
The machine may be lifted and moved in the following fashion:
- At least two operators must perform these operations together;
Maintain the machine in a vertical position when moving, taking care to avoid injuring people and damaging
property.
These instructions must be followed under all circumstances.
Do not stand near the lifting or moving areas under any circumstances.
13 MACHINE INSTALLATION
The machine features adjustable feet, and may be wheeled using the trolley provided by FROMM, otherwise, it
must be positioned on a flat surface and leveled using the appropriate resistance. The machine must have a
suitable container to collect the air pillows produced, or the dispenser or other equipment supplied by FROMM.
FOR FUTURE MACHINE MOVING, PLEASE CONTACT THE MANUFACTURER'S AFTER-SALES
DEPARTMENT, WHICH WILL PROVIDE YOU WITH ADDITIONAL INFORMATION REGARDING MACHINE
POSITIONING
14 VERIFICATIONS TO BE PERFORMED BEFORE STARTING THE
MACHINE
14.1 Environmental conditions
The machine may operate at temperatures between +5° C and +30 °C.
The machine must not be started if exposed to poor weather conditions; in addition, if the
machine is stored, even temporarily, outdoors, it must be suitably protected from the
environment.
14.2 Lighting conditions
The work area must be sufficiently lit, with a minimum value of 500 lx.
15 POWER CONNECTION
CAUTION - RISK OF ELECTROCUTION
The machine is prepared for electrical connection using a male/female power plug, and the cable supplied
allows it to be connected to the electrical mains using a Schuko plug (CEE 7/7)
The power socket to which the machine will be connected must have a residual current breaker installed
upstream and coordinated with the User's ground system.
In addition, upstream of the socket, a power supply circuit breaker must be installed.
The cable supplied is a multi-strand, flexible, PVC-insulated H05VV-F, which must be protected against
abrasion and cutting, and must be positioned such that it does not hinder the passage of people or things.
Caution
Before performing any operations, make sure that the mains voltage and frequency values correspond
to those displayed. The manufacture shall not be held liable for machine connection to electrical
networks that do not correspond to the machine identification label. All electrical connections must be
performed by specialized personnel, and in full compliance with applicable norms.
To Next Page
Loading...
