17
EN
Safety
Safety Observe the following safety instructions for all work described in these operating instruc-
tions.
WARNING! Work that is carried out incorrectly can cause serious injury or dam-
age. All the work described below must only be carried out by trained and quali-
fied personnel. Do not carry out any of the work described below until you have
fully read and understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
WARNING! Machines that start up automatically can cause serious injury and
damage. In addition to these operating instructions, the safety rules issued by the
manufacturers of the robot and welding systems must also be observed. For your
personal safety, ensure that all protective measures have been taken and will re-
main in place while you are in the working area of the robot.
WARNING! Work that is carried out incorrectly can cause serious injury or dam-
age. Before starting the work listed below:
- turn the mains switch of both power sources to the "O" position
- disconnect both power sources from the mains
- put up an easy-to-understand warning sign to stop anybody inadvertently
switching it back on again
WARNING! Risk of serious injury and damage from articles being dropped. All
the screw connections described below:
- must be checked after fitting to ensure they are tight
- must be checked after unusual events (e.g. a crash) to ensure they are tight
- must be checked regularly to ensure they are tight
To Next Page
Loading...
