52
Alignment of
welding torch rel-
ative to the work-
piece
Side view of welding torch/workpiece
- Welding torch (1) at a 45° angle to the
workpiece (2)
- Welding torch (1) at a 5° angle to the
welding direction
- both wire electrodes parallel to the wel-
ding direction
** 'HD' configuration used
*** 'HD' configuration wearing parts, characteristics from 'Speed' configuration used -
the characteristics from the Speed configuration were used to prevent an unde-
sired "run-off" of the weld pool
45°
(1)
(2)
To Next Page
Loading...
