55
EN
Prerequisities for welding
Safety
Prerequisities for
welding
Prerequisities for CMT Twin welding:
- wearing parts fitted to the torch neck
- all system components fitted and installed properly
- compatibility of power sources and remote control systems confirmed
- characteristics version checked
- L/R alignment - welding circuit inductivity and welding circuit resistance aligned
- welding system connected to robot control
- welding system configured in line with the application
WARNING! Incorrect operation or shoddy workmanship can cause serious injury
or damage. All the work described below must only be carried out by trained and
qualified personnel. Do not carry out any of the work described below until you
have fully read and understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
To Next Page
Loading...
