31
EN
Checking the characteristics version
Safety
Checking the
characteristics
version
Use the adjusting dial to select "MIG/
MAG synergic welding" from the RCU
5000i menu
Press the OK button
WARNING! If the equipment is used or tasks are carried out incorrectly, serious
injury or damage may result. All the work described below must only be carried
out by trained and qualified personnel. Do not carry out any of the work described
below until you have fully read and understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
CAUTION! The power sources must be switched on for the following work. This
poses a risk of injury and material damage due to:
- welding current
- unintentional ignition of an arc
- emerging wire electrodes
Until all work is completed, ensure that:
- welding is not initiated by any power source
- the wire electrodes are not fed out
NOTE! The welding start-up configured for CMT Twin is only available with char-
acteristics version V2.9.4. Check the characteristics version to ensure that the
welding start-up configured for CMT Twin is available for the respective welding
system.
1
2
To Next Page
Loading...
