47
EN
Use the adjusting dial to select "MIG/
MAG synergic welding" from the RCU
5000i menu
Press the OK button
- The last "Data" screen called up appe-
ars
In the relevant "Data" screen, press F4
"Filler metal"
- The 1st screen in the wizard appe-
ars ("Select a filler metal")
Depending on the application, apply
the settings for both power sources on
both RCU 5000i devices
2
3
4
5
NOTE! If both wire electrodes are to weld using the CMT process, then the fol-
lowing must be selected for each wire electrode (each power source) on the RCU
5000i:
- which wire electrode is the lead electrode
- which wire electrode is the trail electrode
Refer to the "Welding start-up" section for further details.
To Next Page
Loading...
