50
Use the adjusting dial to select "MIG/
MAG synergic welding" from the RCU
5000i menu
Press the OK button
- The last "Data" screen called up appe-
ars
In the relevant "Data" screen, press F4
"Filler metal"
- The 1st screen in the wizard appe-
ars ("Select a filler metal")
Depending on the application, apply
the settings for both power sources on
both RCU 5000i devices
NOTE! The work described below is performed on both power sources using the
RCU 5000i.
2
3
4
5
NOTE! If both wire electrodes are to weld using the CMT process, then the fol-
lowing must be selected for each wire electrode (each power source) on the RCU
5000i:
- which wire electrode is the lead electrode
- which wire electrode is the trail electrode
Refer to the "Welding start-up" section for further details.
To Next Page
Loading...
