Fronius IG Plus 35 - Setting the Datcom Menu Option

101
Available data connection
‘SIGCDTEST’ will be displayed
4. Press the ‘Enter’ key
If there is a data connection,
‘OKCOM’ will be displayed.
3. Use the ‘Down’ key to initiate
the ‘signal card test’
The ‘signal Card Test’ will start,
‘SIGCDON’ appears on the
display
If the ‘signal card’ is active, it
will emit an acoustic signal in
confirmation.
Important If no acoustic signal
is heard, the signal lines should
be checked.
The set inverter number will
now flash
7. Press the ‘Enter’ key
The number has been applied
8. Press the ‘Esc’ key to exit the
‘IG No.’ menu option
1. Select the ‘DATCOM’ menu
option
2. Press the ‘Enter’ key
The rest of the display depends
on whether
- a data connection has been
established
- a data connection is faulty
or an option has not been
installed
Setting the
‘DATCOM’ Menu
Option
Setting the ‘IG
No.’ Menu
Option
(continued)