Parameters for
TIG welding
Para-
meter Description Range Unit
Comfort Stop Sensitivity
Factory setting on Ignis: 1.5 volts
Factory setting on Ignis 180: 1.5 volts
Factory setting: 35 V (for 2-step mode, 4-step
mode and pedal remote control)
For details, see the TIG Comfort Stop section
starting at page 33
OFF
0.6 - 3.5
Volts
Break voltage (Voltage cut off)
Used to specify at which arc length the weld-
ing process is to be completed.
The welding voltage increases as the length of
the arc increases. The arc is extinguished
when it reaches the voltage specified here
Factory setting: 35 V (for 2-step mode, 4-step
mode and pedal remote control)
Factory setting: 25 V (for the trigger = oFF
mode)
10 - 45 Volts
Factory setting (FACtory)
This can be used to reset the device to its
factory settings
-
cancel reset no
-
reset the parameters for the selected
welding process to their factory settings
YES
-
reset the parameters for all welding pro-
cesses to their factory settings
ALL
Resetting of the selected value to its
factory setting must be confirmed by
pressing the adjusting dial.
Level 2 Setup menu
To set general welding parameters
For details, see the "Level 2 Setup menu" sec-
tion
38
To Next Page
Loading...
