Fronius Primo 5.0-1 AUS - Using the Setup Wizard

4
Download the Fronius Solar.start
app
5
Run the Fronius Solar.start app
4
Connect the end device to the
WLAN access point
SSID = FRONIUS_240.xxxxx (5-8
digits)
-
Search for a network with the
name "FRONIUS_240.xxxxx"
-
Establish a connection to this
network
-
Enter the password 12345678
(Alternatively, connect the end
device and inverter using an Eth-
ernet cable.)
5
Enter the following in the
browser:
http://datamanager
or
192.168.250.181 (IP address for
WLAN connection)
or
169.254.0.180 (IP address for
LAN connection)
The Setup wizard start page is displayed.
The technician wizard is intended for the installer and contains standard-specific
settings. Running the technician wizard is optional.
If the technician wizard is run, it is vital to note the service password that is is-
sued. This service password is necessary for setting the "DNO Editor" menu item.
If the technician wizard is not run, no specifications regarding power reduction
are set.
18