6
(12) TP 08 indicator ... lights up when a TP 08 remote-control unit is connected to the
power source.
The TP 08 indicator continues to glow even after the TP 08 remote-control unit has
been disconnected.
As long as the TP 08 indicator is lit up, it is only possible to set the amperage and
the arc-force dynamic from the TP 08 remote-control unit.
To make it possible to set the amperage and the arc-force dynamic from the power
source once again, as well as from other system add-ons:
- Disconnect the TP 08
- Switch off the power source, then switch it back on again
- The TP 08 indicator remains dark
Description of
the control panel
(continued)
To Next Page
Loading...
