26
“Process” parameters
Rod electrode
welding
The function HCU (Hot-start current) and the available setting range are explained in
the section “Rod electrode welding”.
HCU
Hot-start current - 0 - 100 %
Factory setting: 50 %
The function HCU (Hot-start current) and the available setting range are explained in
the section ”Rod electrode welding”.
Hti
Hot-current time - 0 - 2.0 s
Factory setting: 0.5 s
FAC
Factory - Resets the power source to factory settings
Press and hold the Setup / Store button (7) for 2 s to reset the machine to its original
(i.e. factory) settings. If the display reads “PrG”, then the power source has been reset.
2nd
Second level of the set-up menu (see the section headed “The set-up menu: Level 2”)
TIG welding
NOTE! When you reset the power source, all personal settings are lost in
Level 1 of the Setup Menu.
The reset functions in the Second Level of the Setup Menu (2nd) are not deleted either.
2nd
Second level of the set-up menu (see the section headed “The set-up menu: Level 2”)
To Next Page
Loading...
