Fronius TransPocket 5000 CEL - Option TIG-Comfort-Stop

24
Fig.29 TIG-Comfort-Stop
Fig.30 TIG-welding process with activated TIG-Comfort-Stop option
I
t
set welding current
gas pre-flow
downslope
gas
post-flow
Important! The activation and the setting of the optional TIG-Comfort-Stop function is
carried out by means of the CSS parameter. The CSS parameter is included in the
“Setup-Menu - Level 2“.
Option TIG-
Comfort-Stop
1. 2. 3. 4.
1. Welding
2. During welding, uplift welding torch: the arc is increased significantly
3. Lower torch:
- Arc is reduced significantly
- TIG-Comfort-Stop function triggered
4. Keep torch level
- Welding current is decreased continuously (downslope)
- the arc extinguishes
5. Wait the gas post-flow time and remove torch from the component