28
NOTE! For the “TIG welding” process, only the parameters r (welding circuit
resistance) and L (welding circuit inductivity) are available.
Parameters 2nd
General remarks
Parameter 2nd The function Eln (electrode-line selection) can be set separately for the processes “Rod
electrode welding”, “Rod electrode welding with CEL electrode” and “Special proces-
ses”. The settings remain stored in the memory until the next time any change is made
to the setting in question.
The function Eln (electrode-line selection) and the available settings are described in
the section headed “Rod electrode welding”.
Eln
Electrode-line - electrode-line selection - con / 0.1 - 20 / P
Factory setting for “Rod electrode welding” process: con
for “Rod electrode welding with CEL electrode” process: P
for “Special processes”: con
The function r (welding circuit resistance) is described in the section headed “Measu-
ring the welding circuit resistance”.
CSS
Comfort Stop Sensitivity - response sensitivity of the TIG-Comfort-Stop function: 0.5 -
5.0 / OFF
factory setting OFF
NOTE! We recommend a set value of 2.0. However, if the welding process is
frequently stopped unintentionally, increase the value for the CSS parameter.
Depending on the set value for the CSS parameter the following is required for trigge-
ring the TIG-Comfort-Stop option:
0,5 - 2,0 low increase of the arc
2,0 - 3,5 mean increase of the arc
3,5 - 5,0 high increase of the arc
r
r (resistance) - Welding circuit resistance - x milliohms (e.g. 11.4 milliohms)
The function L (welding circuit inductivity) is described in the section headed “Indicating
welding circuit inductivity L”.
L
L (inductivity) - Welding circuit inductivity - x mikrohenrys (e.g. 5 mikrohenrys)
The function Ast (anti-stick) is described in the section headed “Rod electrode welding”.
ASt
Anti-Stick - ON / OFF
factory setting ON
To Next Page
Loading...
