25
EN
The Set-up Menu: Level 1
The digital power sources come with a wealth of expert knowledge already built in! You
can retrieve and use any of the optimised parameters stored in the machine whenever
you wish.
The set-up menu makes it easy for you to get your hands on this expert knowledge and
on some additional functions, and to adapt the parameters to your particular welding
tasks.
General remarks
Accessing the
set-up menu for
“Process” para-
meters
NOTE! The mode of functioning is explained here with the reference to the
“Rod electrode welding” process. The procedure for changing other “Process”
parameters is identical.
The available parameters can be set separately for each of the proces-ses that can be
selected with the “Process” button (3). The parameter settings remain stored in the
memory until the next time any change is made to the setting in question.
1. Plug in the mains plug
2. Shift the mains switch (8) into the - I - position
3. Use the Process button (3) to select the “Rod electrode welding” process
4. Press and hold the Setup / Store button (7)
5. Press the Process button (3)
6. Release the Setup / Store button (7)
The power source is now in the set-up menu for the “Rod electrode welding” process,
and the first parameter HCU (Hot-start current) is displayed.
1. Press the Setup / Store button (7)
NOTE! Any alterations you have
made will be stored in the memo-
ry when you exit the set-up
menu.
The set-up menu for the process “Rod
electrode welding with CEL electrode” and
“Special processes” is identical with the
set-up menu for the process “Rod electro-
de welding”
NOTE! The comple te list of
parameters for the process “Rod
electrode welding” is explained in
the section headed “Process
parameters”
Changing the
parameter
1. Use the Process button (3) to select the desired parameter
2. Use the adjusting dial (1) to alter the value of the parameter
Exit the set-up
menu
Fig.31 Example for the process “Rod electrode
welding“
To Next Page
Loading...
