Fronius TransPocket 5000 CEL - Connections; TP 4000 CEL; TP 5000 CEL Power Source; TR 2000 Remote Control Unit

7
EN
Connections
TP 4000 CEL / TP
5000 CEL power
source
F ig.3 Front and rear view of TP 4000 CEL / TP
5000 CEL power source
(A) (-)-Current socket with bayonet
latch ... for
- connecting rod electrode or the
earth cable in manual electrode
welding (depending on electrode
type being used)
- current connection for TIG welding
torch
(B) (+)-Current socket with bayonet
latch ... for
- connecting for rod electrode or earth
cable in manual electrode welding
(depending on electrode type being
used)
- connecting the earth cable in TIG
welding
NOTE! If the remote-control TR 3000 is used, always connect the rod electro-
de cable to the (+) current socket.
(C) Blanking cover
(D) Blanking cover
(E) Blanking cover (intended for LocalNet connection socket)
(F) Blanking cover (intended for LocalNet connection socket)
(G) Mains cable with strain-relief device
Fig.4 TR 2000 remote control unit
TR 2000 remote
control unit
(24) Welding current setting dial ... for
selecting the welding current
(25) Arc-force setting dial
Manual electrode welding..for influ-
encing the short-circuiting amperage
at the instant of droplet transfer
0 soft. low-spatter arc
100 harder, more stable arc
NOTE! Parameters that can be
set on the remote-control unit
cannot be changed on the power
source. Parameter changes can
only be made on the remote-
control unit.
(25)
(24)
(G)
(F)
(E)
(D)
(C)(B)(A)